help

  1. Stewie646

    Please help identifying

    These both where my dad's and he as gotten ill. He said the one had a lot of custom stuff done. Can you all help telling me types these are and possibly how much they are worth. I see them range from $290-$600 used like this.
  2. S

    Help me find a fuel tank

    HELP I'm looking for a silver color rdlogics fuel cell for my all aluminum savage xl the site says out of stock. ebay has a few but not silver I'm going to have to find one to complete this project if you can help me get one hit me on here or sdew68@gmailcom
  3. Halle

    Help with savage flux parts

    I recently bought an savage flux hp(already driven it enough to have to fix it a few times) and I just damaged the antenna badly so it's now just over an inch long, it works but the range is terrible so I'm looking for a new one. Are there any specific I should get and where could I get it? I'm...
  4. Scottbot302

    In need of a Collet for the x4.6

    Hey guys, so as some of you may have seen on my other post, I need a collet to complete my savage clutch rebuild. The last one was incredibly worn and had a crack at the base of it. So I decided to throw it out. When I got my flywheel, it came with a collet so I thought it would be great since I...
  5. Markjarvis3

    Glow plugs lasting 2 minutes then stop working

    Got a savage 25 and last 2 times I've tried to use it, the car runs alright for a couple of minutes then either cuts out or if I stop it running it won't start again, been through 2 brand new plugs, was thinking it's more than likely something on the tuning side maybe rather than faulty plugs...
  6. Scottbot302

    x4.6 engine tuning problems

    So my savage has been fine up until about a month ago, where things have totally gone to crap. Started her up today (2/5/17) and was having some poor performance (seemed it was running rich, no surprise there) went to re tune and things have gone to complete crap. The thing can idle good but the...
    • Scottbot302
    • Thread
    • help nitro nitro engine problems savage x savage x 4.6 tuning
    • Replies: 55
    • Forum: Nitro Engines
  7. P

    Help please!! Noobie

    I purchased a HPI Bullet 3.0 Stadium truck yesterday. I was completing the second run through of fuel when I started the engine, it went a full speed (of the ground) then the engine cut off, now I can't pull on the cord anymore what could of happened? I removed the Glow plug but this didn't do...
  8. Scottbot302

    Savage x4.6 - Full throttle problem

    3 Weeks ago I got my first Savage x4.6, this isn't my first nitro (My dad passed his tmaxx pro .15 onto me after keeping it for running for 14 years) but my first Savage x4.6. The problem I am having now is when I go full throttle, and I have no clue what to do because this has never happened on...
  9. H

    savage x 3 speed conversion help!

    hello bashers and thrashers. relatively new to the rc car scene, I bought my first nitro, a RTR savage x 4.6 bigblock. I have purchased a new 3 speed conversion kit and went about dismantling for the conversion, only to find that the spacer that sits between the c clip and the smallest of the 3...
  10. H

    Need some help please

    I have a savage I just aquired and I put an axial .28 engine in and I can barely climb my 30 degree driveway can anyone help
  11. J

    New Members, Vehicles and Owners

    Ok this has come to our attention with the influx of new members..... Anyone who buys an RTR vehicle, either new or used there are things you can do first thing to help yourself with problems that may arise...... 1: FIRST always READ the manual before even trying to run your new model, if you...
  12. samorme88

    HPI RX RF-40, very short range

    hi guys hopefully you can help! Ive recently bought a hpi savage without a massive knowledge of RC in general. The trucks range is very short 15m and it looses range. Unfortunately the throttle stuck open and flew into a fence.... fail safe is now working :bookworm: and new lower arms replaced...
  13. J

    Brake cam

    Wonderin if someone can tell me where the brass puck goes for the brake cam
  14. TomzZeH

    HPI Savage high idle problem

    I start my savage fine , it idles perfectly fine however once its warm, it starts to idle very high and it can't be right (see video) i am new to nitro rc and was just wondering if anyone had any idea on what the problem is and how i can go about fixing it. It also gives out a lot less...
    • TomzZeH
    • Thread
    • help needles nitro savage x 4.6
    • Replies: 4
    • Forum: HPI Savage
Back
Top