- Messages
- 1,871
- Location
- Texas
Here is the HPI manual for setting a 3 speed tranny.
https://www.hpisavageforum.com/misc/manuals/hpi-savage-3-speed-87218.pdf
https://www.hpisavageforum.com/misc/manuals/hpi-savage-3-speed-87218.pdf
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
try 2 turns on the second gear and 4 1/2 to five turns on the third..
When you remove that set screw there is really 2 of them 1 right underneath the one you removed.. once you remove both set screws those gears will come off the shaft, then you will be able to adjust 2nd
That little spring and ball is what adjusts your shift, points.. they go on the clutches.. Ok those two set screws your remove there is another one right right beside it(it kinda goes in at a angle that's where that spring and ball go before you put the set screw over it ...
So sorry If I really confused you but its hard for me to explain , but iam going thought the same thing you are right now... Please guys correct me if iam wrong , and our.. put my words in in something that ain't so screwed up
I have the older .25 rtr with the vertically split trans case. will the horizontialy split case fit this vehicle? I am guessing it will but wanted to make sure. I just did the 3speed and reverse mod and didn't know about the different cases. Bummer but if the horizontialy split case is easier to adjust then that sounds like the way to go.
Welcome to HPISavageForum, a friendly forum to discuss the Savage RC Truck.
Your voice is missing! You will need to register to get access to the following site features:We hope to see you as a part of our community soon!