Hey all, first time posting.
Took my truck out for a run, and it keeps popping into neutral and sticking there. I hit the fuel a few times, or pick it up and drop it then it snaps into gear only to fall back into neutral. Ideas? Do i need to lube this tranny?
Thanks!
Decided to take my 25 out today and before I was halfway through tank one I noticed I only had front wheel drive. I recently changed out all of the driveshafts with MIP so I first made sure everything was still tight in that category and then I thought it could be the spider gears in the rear...
I recently took my transmission apart to adjust the gears. It was shifting only once (it has a 3 speed transmission) so I was trying to correct this....after putting it back in it does not shift at all....I took it back out tonight and realised I’d made the stupid mistake of putting RED loctite...
Dose anybody know how to adjust a two speed transmission I'm trying to get more tork on take off and more speed in second gear iv already tried changes with the clutch and fly. Just trying to not buy a 3 speed. For my savage x 4.6 big block.
I tried to adjust my shifting I located the clutch holder then held spur and turned the wheels and nothing happened my drive shafts didn't move.runs fine just doesn't shift what gives
Hey guys I'm new here to your forum.
I'm gordy I have 10 savages intros. Got 10 traxxas love them all.
But have guestion on one that I'm working on I bought used it a nice fairly new one. But runs great but shifts into second gear and stalls. Havnt had time to look in tranny . But that what I'm...
Hey everyone,
So this is my first post here, but I have been lurking around thus fourm for years now,
I have had an issue with my savage x for quite some time now, just been too lazy to fix it! Long story short I only have second gear as I'm missing the little adjuster pin and spring/ ball...
Anyone know the base setting for 3 speed from full screwd down other than trying especially on the 2nd as I don't want to take it out all the time (to lazy )
hello bashers and thrashers.
relatively new to the rc car scene, I bought my first nitro, a RTR savage x 4.6 bigblock.
I have purchased a new 3 speed conversion kit and went about dismantling for the conversion, only to find that the spacer that sits between the c clip and the smallest of the 3...
I recently bought 3 savage flux XS not fully reading the manual burned up all 3 slipper clutches and all gears mashed and stripped.
Any one found hardened gears for the XS?
I was just shimming up my output shaft on my transmission. I noticed on the brake side of the housing there is a second channel behind where the 5x10 bearing seats
The second perfectly seats a 8x16 bearing. So I put one of each on the stepped shaft and everything seams to fit perfect. Don't see...
Hey guys! This will be my first thread here because i am kind of new to the RC world. i have enjoyed it a lot so far but i am at a dead end and cant figure out why my savage 4.6 wont shift. I got it off of a classifieds site and traded it for a pocket bike i got for $15 and it wasn't running at...
I ruined the gears on my transmission on my savage xl, It has reverse on it. I have a savage xl that has a 3 speed transmission in it that I would like to put in my x. The xl has no reverse and I would like to know if I can take the reverse out of my 2 speed transmission and install it in my 3...