Recent content by M0rphin3

  1. M0rphin3

    You think this LiPo is "puffed?"

    Result of a crash or cause?
  2. M0rphin3

    What To do

    Check over it and make sure all screws / nuts are tight. Check diff's to make sure they are there and not chewed. Use fresh battery / hump pack. Test all electronics before trying to start the mill.. Replace glow plug with new.. Attempt to turn the mill over by hand and make sure you can before...
  3. M0rphin3

    Brakes

    The screw has a smooth shank and then the threads.... he is saying tighten them all the way down untill the smooth shank is flush
  4. M0rphin3

    Brakes

    If you can move it by hand and see the "brake piston" push out onto the plates, then more then likely the screws that hold the plates on may be too loose.. i would make sure that the piston is moving before anything else
  5. M0rphin3

    What Do You Look Like !!!!!

    This is me and my Fiancee, photo was takin about 2 weeks ago in Columbus Ohio
  6. M0rphin3

    Brakes

    Are you running a throttle mod or still the factory setup, any pictures available, this would help greatly
  7. M0rphin3

    A Ruin A Wish Foundation

    Granted, But you become a selfish ignorant drunk who everyone despises I wish the work weeks were flipped, 2 days of work, 5 days of weekend
  8. M0rphin3

    A Ruin A Wish Foundation

    Granted - but now the "ABCD" charger costs $1000.00, I wish WalMart would implode
  9. M0rphin3

    HPI BP Diff VS Cen GST DIFF !!!

    On behalf of frddy lol.. the BP Diffs can be dropped right into the stock cases, they are stronger then the stock by far, the reason i mentioned is hellfire cases is because now the only way you are going to ruin these gears are by the cup bearings failing, if u get some good boca bearings...
  10. M0rphin3

    HPI BP Diff VS Cen GST DIFF !!!

    Thanks frddy, ill check around for them :)
  11. M0rphin3

    steering locking up?!?!?!?!

    Is your steering getting stuck in 1 direction, after hard landings or rollovers? Can u push the wheels back in position with your hands after they get stuck? If this is the case check the servo saver, if the spring is too loose it will allow it to rotate past the apex of the post, causing it to...
  12. M0rphin3

    What did you do today.

    Currently still at work till 5:30, its 4:46 now, Did take an extra long lunch break to go home and get my new present to myself that showed up today.. lol didnt want it sitting on my front porch + it is raining so... Probably head home after work and have dinner with the fiance and then its all...
  13. M0rphin3

    HPI BP Diff VS Cen GST DIFF !!!

    Bank you got a link to the shims you used for those cups?
  14. M0rphin3

    HPI BP Diff VS Cen GST DIFF !!!

    Hellfire Aluminum Cups Hellfire Nylon Cups
  15. M0rphin3

    HPI BP Diff VS Cen GST DIFF !!!

    I may be wrong but, I believe you can use the hellfire diff case which uses the 8x16x5 cup bearings, and then use the hpi bp diff gears on those cases, you end up with the BP gears and the better 8x16x5 bearings
See more
Back
Top