Stonecold2k1
Member
- Messages
- 6
Hi my husband has the savage K 5.9 and he has changed it from a rota start to a pullstart but it's no turning the engine over at all. Please can anyone advise him on what he can do. TIA
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
He didn't buy a new One way bearing all he did was take the rota start off and put the pull onHe most likely installed the one way bearing on the back of the engine backwards. Like the name suggests it only spins the shaft one way, if you put it in backwards it will just spin. The part of the one way bearing with the silver metal lip on it goes towards the front of the truck
He didn't buy a new One way bearing all he did was take the rota start off and put the pull on
Hi no he didn't take the back plate off he said he didn't need toDid he take the back plate off, because there is a small spring loaded pin in the crank that the starter catches. It pops out quite easily when taken apart.
Ok, Probably the one way bearing, check that it isn’t slipping. If it is try spraying a little penetrating oil in, put in on the shaft and turn it a few times. Take it off clean it then see off it works.Hi no he didn't take the back plate off he said he didn't need to
Welcome to HPISavageForum, a friendly forum to discuss the Savage RC Truck.
Your voice is missing! You will need to register to get access to the following site features:We hope to see you as a part of our community soon!