MikeK1981
ChondroManiac
- Messages
- 2,037
- Location
- Humboldt, CA
OK guys this is the first time I have completely taken the mill apart. I'm looking at the rear bearing and the balls are exposed and they move around inside the race. Is that normal or is the bearing shot? It still seems to spin smoothly. The front bearing seems like it's in good shape still. To me the piston and sleave still look good and in the one pic you can see where the OWB rubbed on the connecting rod when the pin sheared off. You guys know where I can get just the bearings for this mill? HPI just sells them with the new block it looks like. What do you guys think? Maybe new bearings and seal it up and see if I can't get it going again? The pics are not good but do you guys see anything there that's bad?