Slimshamis
Well-Known Member
- Messages
- 226
Hey guys I'm getting super frustrated with this thing an I need some help. I have a xl flux running MM esc with the torq 2200kv motor, with 2 3s turnigy 45c50c burst lipos. I originally thought my LVC was to high at 3.4 so I put it at 3.2 per cell.
Here is the problem on fully charged lipos I can roll all the way up to full throttle no problem after about 10 min if I try rolling up to full throttle it cuts out, at this point I can come to a complete stop slam full throttle and make it backflip but if I roll on the throttle all the way up to full throttle it cuts out?
Should I turn punch control on?
Now I have a buggy with the same setup but with a MMM 2200kv and not a torq motor an I pit these exact packs in there and have no problems this is why I am stumped is the castle motor more efficient than the torq or something?
Please help me out on this one guys I'm so frickin frustrated right now
Shane
Here is the problem on fully charged lipos I can roll all the way up to full throttle no problem after about 10 min if I try rolling up to full throttle it cuts out, at this point I can come to a complete stop slam full throttle and make it backflip but if I roll on the throttle all the way up to full throttle it cuts out?
Should I turn punch control on?
Now I have a buggy with the same setup but with a MMM 2200kv and not a torq motor an I pit these exact packs in there and have no problems this is why I am stumped is the castle motor more efficient than the torq or something?
Please help me out on this one guys I'm so frickin frustrated right now
Shane