Well I finally got me some byrons today for my savy after my 140 round trip drive..So I get home and fuel up the savy so i can heat cycle the lrp spec3..Well after changing the stock plug to a MC59 for breakin,I heated the mill with hair dyer to 140 degrees.. So I primmed the mill and pulled on the pullstart about 8 times with no luck..So i thought maybe it might of been flooded, took out plug and pulled the pullstart to get all of the nitro out..Then I repeated the steps above again with no bad word luck..I tried this several more times for about a hr with no bad word luck.. My question is it ok to lean it a little to see if that will help..I checked and made sure that i had about a 1mm gap on the carb..I am running byrons 30% with a MC59 plug...Any and all help would be greatly apreciated..