Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Ok i am wondering how do you get the brass collet that the flywheel goes over off the crank? :dunno:
When you have the back plate off and the piston out tap the crank shaft on a table and it will slide off. don't WAKE it just a gentle tap ..
This is how I do it. It is an eye glasses flat tip screw driver. giggle it to widen the gap, pull it off.
http://i1014.photobucket.com/albums/af263/joeguamagat/DUMB THINGS/0c269daf.jpg
http://i1014.photobucket.com/albums/af263/joeguamagat/DUMB THINGS/8d777c9d.jpg
http://i1014.photobucket.com/albums/af263/joeguamagat/DUMB THINGS/85c48c3d.jpg
Hope this helps.
this is what I do too if stuck. I don't reuse these after I pull them too.. I toss in trash and replace. Thats your call but I have had a reused one slip after being cleaned up well too ..
Welcome to HPISavageForum, a friendly forum to discuss the Savage RC Truck.
Your voice is missing! You will need to register to get access to the following site features:We hope to see you as a part of our community soon!