Hello all, first time poster long time lurker. I have a question for the experts here. I am piecing together an "ebay" flux (for lack of a better term). So far I have everything I am going to be needing to make this happen, but I ran into a problem with limited suspension travel in the front. I have the TCS 5mm TVP's and Fast Lane Bulkheads. Coming out from the Bulks are RPM arms (upper i the 0 degree arm for right now). I am running the Integy (they were available and cheap) blocks and knuckles and the steering linkage is from Lunsford and the shocks are the Big Bore savage shocks. Problem I am having is that the lunsford rod ends and ball studs seem to be binding and not allowing the suspension past half downward travel. Am I missing something here?? I have both ball studs on the underside of everything (Knuckle and linkage arm) but it will not allow the arms to droop to full down travel?