Markjarvis3
Member
- Messages
- 43
Trying to source either a rota start or new pull start for a axial 32 engine.
Flicking through other forums somebody said that a 4.6 pull start should fit right on, but it doesn’t as I had a rota start for one and it doesn’t push up tight into the engine.
Just wondered if anybody could shed some light on the situation or point me in the right direction before I throw the engine away! Getting frustrating. I’ve never used a engine Where the starter doesn’t use a one way bearing and the axial is a solid hex on the crank.
Also engine seems too tight even when it’s not flooded in comparison to a 4.6 I have.
thanks
Flicking through other forums somebody said that a 4.6 pull start should fit right on, but it doesn’t as I had a rota start for one and it doesn’t push up tight into the engine.
Just wondered if anybody could shed some light on the situation or point me in the right direction before I throw the engine away! Getting frustrating. I’ve never used a engine Where the starter doesn’t use a one way bearing and the axial is a solid hex on the crank.
Also engine seems too tight even when it’s not flooded in comparison to a 4.6 I have.
thanks