Recent content by carlg1

  1. C

    Futaba receiver

    Yes, only by chance that I spotted it, not had it out running yet but it seemed fine with wheels off the floor
  2. C

    Futaba receiver

    Think I have sorted it. The E.P.A on the steering servo was a little too much and when I turned aggressivley from side to side it must have been glitching and was causing the throttle servo to glitch. Reset my E.P.A and it now doesn't do it .
  3. C

    Futaba receiver

    Thanks for the reply Pope, yes use normal batteries in tx but will also try a rebind.
  4. C

    Futaba receiver

    Hey guys i have the Futaba 3pm tx and a R603FF receiver, at the moment the receiver is running on rechargable AA batteries which would equal 4.8v.The manual states it needs 6v.The reason i am asking is after landing a jump it takes a few seconds until i can get control again and also today the...
  5. C

    40 series tyres

    am thinking of getting the proline bow ties 40 series or axial terra-izer 40 series tyres for racing mainly on grass, any good or bad points about either tyres
  6. C

    Picco .28 roto-start ?

    not 100% sure, but think an hpi f4.1 one will fit and a 12mm hex to act as a spacer
  7. C

    BB's: Post your HPI Big Bore set-up's here (Piston/oils/Pre-load clip's)!

    has anyone tried the stiffer springs, am running the pink at mo, will a stiffer spring make it roll over in the corners
  8. C

    IRC- lcg tvps

    cheers mate for your reply, all the info i needed,prob will get the 1" and 6mm ext tvps as it gives me the option for further upgrades in the future,i have a drag modded picco from adam so hopefully it should still pull the wheels up, one other question, will the roto start work with these tvps,
  9. C

    IRC- lcg tvps

    Hi guys, i am in a dilemma as to which IRC lcg tvps to buy, am leaning towards the 1" back and 6mm forward ones but was wondering if a standard hpi GT2/flux body shell would fit, is it a matter of re-drilling the mounting holes or would it look silly, also which shell would fit if the flux one...
  10. C

    Pro-line bowties tyres

    thanks joe, am looking for a low profile version of the hpi dirt bonz, do you know what sort of size the side wall is compared to dirt bonz or hpi phaltlines for example, also how is the picco from adam, mine is still spot on, only 2 gallons on it
  11. C

    Pro-line bowties tyres

    thinking of getting these for grass track racing, does anyone know how tall the piccogirl40 series bowties are, thanks
  12. C

    xl tvps

    cheers guys, i thought that was the case but i read in a thread on here somewhere that someone said the xl ones where lcg, glad you guys could clarify that for me as thinking of getting some lcg tvps but leaning towards the flm ones, just a bit awkward getting them in the U.K
  13. C

    xl tvps

    Does anyone know if the hpi xl tvps are classed as lcg ones or are they the same as savage x ones but longer :picco:
  14. C

    modded engines

    good replies guys, thanks for info frddyj but as its an old thread i have already received my drag modded picco from adam and its an animalhpisfflash piccogirl runs all day long at about 190 to 210 at tops
  15. C

    Driveshafts too short?

    Also try a piece of fuel tube inside the diff cup, tried this as couldn't get any O rings, works a treat
See more
Back
Top