Spur question

[Dooley]

I feel like I am missing something.

I have the pin>hub>plate>pad>spur>spring>washer>nut

No matter how tight I tighen it all down it slips so bad that it wont even roll.

 

[ShakerCo]

I feel like I am missing something.

I have the pin>hub>plate>pad>spur>spring>washer>nut

No matter how tight I tighen it all down it slips so bad that it wont even roll.

isn't there supposed to be another plate b4 the spring?

 

[frddyj]

isn't there supposed to be another plate b4 the spring?

Yep Shakes, there is a small metal spacer that presses into the spur gear then the washer with the hex cut-out goes over that, then the spring, then the nut. Good thing to check because it is an easy piece to forget when you are swappin' gears.

 

[AllanQ]

The hex washer is supposed to go between the spur and the the spring. Hope this helps

 

[Dooley]

i was looking at the hex'd washer and noticed it was rounded out. the spur I'm running now is a RRP and came with a bearing to put in rather than using a bushing.

Ill get some new hex washers and pray thats all it was 🙂

thanks for the info guys.