Running on 3s for Bashing. Whats the best gear setup for it?

[Hammer]

Thanks for the reply. I use a Lectron 2S 5200 mAh 50C roar approved LiPo. I will try some small steps to see what happns. The emh esc has overheat protection so I should be ok.

 

[Hammer]

I just tested. Setting 9 is timing on the emh. It's default value is 5. I have tested value 6. Instantly more backflip capable. Landed upside down couple of times. Value 7 would have been sufficient probably for full flips but ground was too slippery. And after 5 minutes in value 7 the overheat protection kicked in. Seems it fully resetted the esc in the proces as well.

 

[Boost13az]

Do those 2S 7000's fit without any modification? I just got some of their 2s 5000's

The gens ace 7000 2s fits, but you either need to make or purchase 90 degree bullet connectors into the battery, also called "low profile". I made mine, wasn't hard. one of the best products I've purchased.