wildchild27
DR. DISASTER
- Messages
- 748
- Location
- Etna Green, IN
when you mod an old motor do you have to go through the steps again?
-
Ask questions. Share your HPI Savage knowledge. Register TODAY!
re break in
- Thread starter wildchild27
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 3,849
- Location
- Worthington, MN
No because the sleeve and everything have been heat cycled many times before the modding. I however do usually give it a quick heat cycle then run it nice for a little bit just to get everything seated and sealed back up good.
You will have to retune thought.
You will have to retune thought.
thats good to know for my next modded mill; i was so anxious when i got mine back from modding i "gripped it & ripped it" :duh:
