picco rotostart

[carlg1]

as i am in the uk i cannot get ofna parts very easy, does anyone know which rotostart backplate fits the picco .28 p3 pullstart version, thanks

 

[Grumpy1822]

The hpi s25 rotostart and a 12mm wheel hex to act as a spacer in between to keep the shaft from walking. I use a tc3 hex. Just stick it in the backplate as a spacer and use the spring. The hole in the center of the wheel hex is a perfect fit. Mods you might want to stickey this somewhere as it seems to come up often.

part#s
HPI87117
TA 3950 (tc3 12mm wheel hex)

 

[carlg1]

thanks mate, is the spring included and where does it go, thanks

 

[Grumpy1822]

Yes the spring is in your motor now. just reuse putting it right in the center hole of the 12mm hex.