ocremy
Member
- Messages
- 41
- Location
- Los Angeles, California
i installed my new os engine weeks ago, finally.... my first monster truck break-in, its harder than i thought. i can't tune it right.... i read manual and started with default setting, checked carb opening and break point and more... (i did 2 break-ins on on-road cars. i had no problems) ok.. here i go..
1. Its Very hard to start the eninge (i can't figure it out its too lean or rich)
2. i can't make my engine run properly.. it stalls if i give a little gas (with Glow Starter plugged)
3. once, it reached 205 i drove around 3 mins (heat cycle) turned off i waited until engine got cool, and if i try to start the engine again.. it goes to #2 prob again.
i used 2 tanks of nitro fuel 20%(traxxas) and gave up..(actually i had to leave. i live in Los Angeles @ Cali, i went to some local high school soccer field @ 7am.. soccer players asked me to leave after one hour... ha... if my savy was running properly, i could've break one of their leg.....ooops. --;;
anywayz, i need some serious detail help here...
Thanks mill,
Orange County remy
1. Its Very hard to start the eninge (i can't figure it out its too lean or rich)
2. i can't make my engine run properly.. it stalls if i give a little gas (with Glow Starter plugged)
3. once, it reached 205 i drove around 3 mins (heat cycle) turned off i waited until engine got cool, and if i try to start the engine again.. it goes to #2 prob again.
i used 2 tanks of nitro fuel 20%(traxxas) and gave up..(actually i had to leave. i live in Los Angeles @ Cali, i went to some local high school soccer field @ 7am.. soccer players asked me to leave after one hour... ha... if my savy was running properly, i could've break one of their leg.....ooops. --;;
anywayz, i need some serious detail help here...
Thanks mill,
Orange County remy