Nova Clutch

[Java*]

Nova clutch, mugen 1mm springs, mugen pilot nut, and a pull start from a k4.6! Cant wait to try it out tomorrow! here are some pics 🙂

 

[Chris]

Nova clutch, mugen 1mm springs, mugen pilot nut, and a pull start from a k4.6! Cant wait to try it out tomorrow! here are some pics 🙂

Good idea putting the set screw weights in there...I didn't like how hard the clutch engages without the weights.

I have the exact same setup in both my trucks. You'll like it.

 

[Jeremy]

I run no weights ... I like it better .. Hits hard off the line

 

[xsavage3148]

I run no weights ... I like it better .. Hits hard off the line

Is this what i would want to do if i want instant response? i want that **** to just get up and go!!!

 

[SunkenMetal]

Nice pics... let us know how those nova clutch screws work out on the 5.9, i was thinking about putting them on my 5.9....

 

[Chris]

I run no weights ... I like it better .. Hits hard off the line

For the motors I run I didn't care for the truck to constantly be on it's lid. My motors have *way* too much torque for that high-RPM stall converter feel. Pops the thing instantly on the lid.

 

[Shaun]

ya i agree, bashing isnt a whole lot of fun if you have to keep running over to your truck to flip it right side up all the time lol

 

[Chris]

I put (2) weights per shoe actually. (1) in the middle and (1) on the far outside of the hole. I also have the 1.1mm springs to hold it tighter.

It will still flip right over with the RBMods SureFire 32R. Nasty motor similar to the 5.9 here.

Back on topic (sorry). hehe

 

[Jeremy]

Mine don't instanly flip on the lid .. I run 20/47 w/ the lrp spec 3 and 18/47 w/ the surefire .32r

I have lots of vids check them out if you like

 

[Chris]

Mine don't instanly flip on the lid .. I run 20/47 w/ the lrp spec 3 and 18/47 w/ the surefire .32r

I have lots of vids check them out if you like

I am running 18/47 on my SF 32R and 18/49 on my Axial .28 and they both just lift right up. Same clutch setup too.

Cool!

 

[Jeremy]

Ohh yea I run 1.0mm spring

I don't care for the 1.1's

 

[Java*]

so far the clutch is working ok, I'm taking it easy though havnt really done too much with it. Trying to get the trans tweaked to the 17/47 gearing. Soon as I can get on it and get through some gears ill let you know how it works out 😀