need a little bit of carb help

[Mickey]

i got my new axial all fitted up to be put in my truck and i found a small annoyance. I'm wondering if it can be fixed? the hsn body is angled way forward , my question is can the carb body be turned to acheve a more 90 degree angle?

oh some pics of the annoyance

sorry for the dark pic camera went dead right after the pic and wouldnt flash

thanks for any help in advance

 

[texasavage]

Sorry I don't have any way to fix it , but my Surefire .32r was the same way.
Does this effect anything besides fuel routing and looks?

 

[Grumpy1822]

Yes, you can loosen the hsn housing (note the hex) and spin the banjo wherever you want. Hold it and tighten.

 

[texasavage]

I think he's looking to have the hsn at more of a 90 deg verticle postion which would have the inlet pointing more to the rear or forward depending on which way you turn it. Right now his inlet is pointing more upward (about 70-80 deg) in the pic, which I'm not sure of anyway to fix without a differant carb. But I could be wrong

 

[Mickey]

I'm thinking the same thing texas I'm hoping purenitro or crash sees this I'm actually going to pm crash and see if he has any ideas. he seems to be the axial expert. thank you for the advise grumpy but i had at the point of takin the pics already turned the bango around, lol it was pointing down.