LRP Break In Question

[fouteros]

hello,
can you tell me what are tha break in settings of the zr.30spec2

 

[Londoner]

Mid range 2.25 turns out from all the way in, and 2.75 turns out on the main needle.

Its in the manual that should have came with your engine http://www.lrp.cc/fileadmin/lrp_anleitungen/anl_25002_ma00191-lrp-zr30-spec2-pullstart-manual-e.pdf

Let us know how the break in goes, I'm gonna break my one in in the next week or so, iv read theyre very tight and need a long break in.

 

[fouteros]

it came
today its very tight
but i will post a review
I'm sealing it right now

 

[maximusraylius]

sealing it? is it messed up already? if its brand new it shouldnt need sealed came sealed with o rings from factory... hmmmmmm don't get why ppl do that to perfectly good mill..let us know how it works out..

 

[yeroc1982]

2.75 turns? In the manual it actually says 3.75 turns.

 

[Londoner]

LRP ZR .30 spec 2 Factory settings copied and pasted from the online manual.


• Mid range: 2,25 turns
• Main: 2,75 turns

Source, http://www.lrp.cc/fileadmin/lrp_anleitungen/anl_25002_ma00191-lrp-zr30-spec2-pullstart-manual-e.pdf

 

[fouteros]

ok folks it runs great
i have a gallon through it

 

[fouteros]

i have the manual it says:
• Mid range: 2,25 turns
• Main: 2,75 turns

 

[yeroc1982]

Sorry I was looking at the .28 break in

 

[Bankrupter]

sealing it? is it messed up already? if its brand new it shouldnt need sealed came sealed with o rings from factory... hmmmmmm don't get why ppl do that to perfectly good mill..let us know how it works out..

LOL max.. Nice to see you kept up where I left off ...

-----------------------------------------------------------------------
Now wheres the vid of these things ???