getting ready for break in

[Hawkeye67]

i read some were that you are suppose to set your piston at bottom dead center after each break in setion how do you do that i rotated the gear counter clock wise to the bottom but no click like in the video about storing your moter for the winter his was out of the truck mine is in and hooked up any advice would be aprectiated thanks

 

[sharkattack99]

you could take the glow plug out and use a flash light look down the hole and see that its on the bottom. once at the bottom take a marker and mark the top of the flywheel then when you turn your engine off after each tank for break in make sure that the mark is on the top and you will know that the piston is on the bottom.

 

[Hawkeye67]

tune up

sounds like a good suggestion i did not think of that thanks for your help sharkattak99

 

[sharkattack99]

glad i could help.