Hi all - gonna sound totally dim now but I've just got a DX3s and I'm about to install the receiver but I don't know which way to plug the Flux/mmm into it- no signs for pos/neg on the receiver body so don't know which way to connect the pins. If I go with the same orientation as the stock Rx then the brown wire
on the mmm and the black wire on the servo would be next to the outer edge of the casing - away from the writing - is this right? I just don't want to fry anything.
I remember reading posts about setting up a DX3s with a mmm/Flux but cannot find the info again. I think it was something about End Point Adjustments - appreciate any advice on this - and anything else on running this Tx setup. Don't want to mash something up from newb error. Cheers
on the mmm and the black wire on the servo would be next to the outer edge of the casing - away from the writing - is this right? I just don't want to fry anything.
I remember reading posts about setting up a DX3s with a mmm/Flux but cannot find the info again. I think it was something about End Point Adjustments - appreciate any advice on this - and anything else on running this Tx setup. Don't want to mash something up from newb error. Cheers