Hey guys,
I have my FLM LCG TVPs (standard length) and I was installing them but ran into a screw hole issue.
The hole that allows the bolt to connect to the servo plate forward cross member (right next to trans) is too small for the bolt to fit through. Anyone else run into this issue? Should I just drill the hole out to allow the bolt to pass?
Working on my mid-tank as well. Following bits and pieces from everyone's work, most of the ideas come from Judge's.
I have my FLM LCG TVPs (standard length) and I was installing them but ran into a screw hole issue.
The hole that allows the bolt to connect to the servo plate forward cross member (right next to trans) is too small for the bolt to fit through. Anyone else run into this issue? Should I just drill the hole out to allow the bolt to pass?
Working on my mid-tank as well. Following bits and pieces from everyone's work, most of the ideas come from Judge's.
Last edited by a moderator: