mekios
Member
- Messages
- 40
- Location
- Athens, Greece
This is my engine mount, the stock one. I said ok after 8lt it should be normal to break. By the way i have to comment here that having listened to guys in here i had steel spur gear so nothing stripped, even when the engine was about 20degrees off it's original position.
I replaced it with another one. After 1 tank on the new one it's cracked again, though only slightly.
What am i doing wrong guys? Is something bad happening to my mill, that keeps breaking those mounts? Could it be that i replaced the orignal mill screws with innovative-rc ones?