Hi savvy gurus.
so i installed a bunch of new parts on the truck in the last month. here are the main ones
3sp with hs gear
lrp z28s3
jammin jp4 pipe with stock header
new radio
first off...this thing rriiiiiiiiiiiiiiiiiiiiiiiiiips
it was running fine until my receiver batteries crapped out. i changed the batteries fired it up and the motor would rev but it was not going anywhere. feared the tranny or diffs.
i read that if it was the diffs, i would hear sounds when i lift the rear tires and try to spin them. well i tried that on the fronts and rears, and it would try to move all four wheels..so i think the diffs are fine.
well before tearing it apart, i inspected the flywheel and noticed when i was turning the spur gear, it wouldnt grab the slipper clutch..do you guys think its just loose? i tried tightening it this morning and tried running it, but the same thing happeend. do you guys think i just need to tighten it or could it be something else? thanks all!
so i installed a bunch of new parts on the truck in the last month. here are the main ones
3sp with hs gear
lrp z28s3
jammin jp4 pipe with stock header
new radio
first off...this thing rriiiiiiiiiiiiiiiiiiiiiiiiiips
it was running fine until my receiver batteries crapped out. i changed the batteries fired it up and the motor would rev but it was not going anywhere. feared the tranny or diffs.
i read that if it was the diffs, i would hear sounds when i lift the rear tires and try to spin them. well i tried that on the fronts and rears, and it would try to move all four wheels..so i think the diffs are fine.
well before tearing it apart, i inspected the flywheel and noticed when i was turning the spur gear, it wouldnt grab the slipper clutch..do you guys think its just loose? i tried tightening it this morning and tried running it, but the same thing happeend. do you guys think i just need to tighten it or could it be something else? thanks all!