Recent content by The_DDub

  1. T

    Upper arm pins

    Any ideas or threads on how to keep them in place without using the bumper arms? I'm tired of them coming out. I want to fab some piece of metal to block them and then screw it down using the holes right underneath the front of the arm pins. I want to use something a little more stealth than...
  2. T

    most dissapointing hop ups ?

    Axial Beadlocks. They are not built for bashing. Crawling and shelf-queen, OK. I read alot of people don't like the dual disk brakes. I wonder why, they are awesome, yeah, I had to replace the discs and pads, but I can make my savvy flip front-end over if I brake hard enough. They STOP the big...
  3. T

    FLM LCG TVP question

    Thanks Allan. My goal here is to build a tough basher. I'm also tired of buying fuel tanks due to the the shock towers crashing into the tank when landing on the rear/top. The servo plate only came with 2 crossbars, so I know I couldn't have mixed it up :) But the chassis did come with a cross...
  4. T

    FLM LCG TVP question

    I'll post pics tonight. But I don't want to send it back, I need to get this thing together!
  5. T

    FLM LCG TVP question

    Hey guys, I have my FLM LCG TVPs (standard length) and I was installing them but ran into a screw hole issue. The hole that allows the bolt to connect to the servo plate forward cross member (right next to trans) is too small for the bolt to fit through. Anyone else run into this issue? Should...
See more
Back
Top