Recent content by nitrorich

  1. N

    New Flux and some questions

    nice truck I'm trying to sell my nitro savage to go to eletric either a e savage or a e max less breakige i think nitros stall you have to chace them battary what can go wrong other than dead battarys
  2. N

    what is the best engine for savage?

    it helps if it runs to
  3. N

    what is the best engine for savage?

    one that runs
  4. N

    Looking for special graghics!

    jakal hobbies.com
  5. N

    Tranny prob - not shifting

    trans if it locks up when you roll it backwards it chould be to mesh is to tight i had that happen.if you don't shift after all that adjusting replace the clutch holder in the transmission.ihave done it all and mine still don't shift
  6. N

    how to drill body holes

    this methoed works very well . use play dough on the bottom of the body were you think the body hole will go.spread the play dough across the body so it goes from one side to the other of the body.then line up the body with the body post makeing sure the body is stright then push the body on the...
  7. N

    Glow Plug

    6r76756te66
  8. N

    modding stock shocks for better control

    yes use the rubber bushing in the shock boot the truck will be level and wont roll.i did mine and i can turn at full throttle without rolling it over
  9. N

    my truck dies when i remove the glow plug ignighter

    its a new plug and when its warm its runnig at 180
  10. N

    my truck dies when i remove the glow plug ignighter

    ok i have a os 30 with a mcoy mc9 glow plug witch is new when i first start my truck the motor dies when i remove the glow plug ignighter.but if i leave the ignighter on it and do 2 laps around the take the ignighter off its fine all day.
  11. N

    2 speed wont shift

    ok i ran my truck today it shifts great so the stock setting is all the way out and 1 1/4 in
  12. N

    2 speed wont shift

    no its like 5 to 6 from closed but your not supose the close it you damage the spring hpi says
  13. N

    2 speed wont shift

    i talked to hpi the setting is the screw goes all the way out counter clockwise and one and a half in clockwise
  14. N

    2 speed wont shift

    so do i put the screw all the way in and out 1 and half
  15. N

    2 speed wont shift

    my savage will not shift into 2nd.it dose great wheelies so i figure its in first plus the motor revs high at full throttle.anyhoo i turned the adjust screw all the way in and went 1/4 turns out I'm now at 4 turns out still wont shift.anyone no roughly were the screw should be (how many turns...
See more
Back
Top