cooling head fin bend

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

dirtbasher

Active Member
Messages
114
hi guys,
played my mt today n it flip,landed upside down on hard rock surface. the top fin of the cooling head is bend as shown in the pics. am i goin to hav any problems,like engine heating up more than usual?
 
You should be ok with a bent fin. it just shows that you been running it hard..lol. Just to be sure, I would check the outside of the motor and make sure there are no cracks in the block. I am sure there isn't any, but check just in case. You can also take a screw driver and bend it back so its somewhat straight. Just be carfull not to break the fins below it.
 
nice carnage basher, i like how you roll. time to click drummer cage in my siggy? rockout
 
You should be ok with a bent fin. it just shows that you been running it hard..lol. Just to be sure, I would check the outside of the motor and make sure there are no cracks in the block. I am sure there isn't any, but check just in case. You can also take a screw driver and bend it back so its somewhat straight. Just be carfull not to break the fins below it.

thx AllanQ,
i tried straighten it wit the screw driver but it didnt work. the metal is tough.
hav checked if thers any cracks n its fine. i just leave it b4 i break it,ha ha!
 
thx frddyj,
wats drummer cage in my siggy mean? I'm kinda new in this lingo.


click on the words "us custom cages", in frddyj posts, thats a member here that makes awsome roll cages that stand up to a beating!!
 
Last edited by a moderator:

Latest posts

Members online

Back
Top