what clutch shoes

[carlg1]

are the aluminium clutch shoes better than the stock ones for a high powered mill, any good recommendations would be grateful

 

[Londoner]

I like the Dynamite max life shoes, DYNP5180. By far the best shoes I've tried, just put my second set on and I doubt I'll use any others in the future.

 

[carlg1]

thanks mate, should be available in uk also

 

[Londoner]

JE Spares is where I get mine from. Some other places list them too but I've bought from JE a few times now and always had good service from them.

http://www.jespares.com/nitro-model...e=flypage.tpl&product_id=7630&category_id=893

Cheap link for Mugen 1.1 springs too, I've ordered 2 lots of these now 😉

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=400077214205

 

[carlg1]

thanks again londener,what mill are you running with these shoes

 

[Londoner]

No worries mate, LRP .30 Spec 2.

 

[carlg1]

nice engine,plenty of power, i'm a bit new to the upgrated clutch side , what does each different size of clutch springs do

 

[Londoner]

Heavier spring - later engagement, lighter spring - earlier engagement.

I think the general rule of thumb is lighter springs for loose surfaces, clutch engages at an earlier RPM giving greater traction off the line - less wheelspin and heavier springs for higher traction surfaces but I find 1.1 works well for me all round.

 

[carlg1]

thanks again londoner