stock savage spur and clutch bell combo

[addicted to rc]

what is the stock spur and clutch bell set up on savage x 4.6 just ordered a new truck and would like to get a steel spur for it before it gets to me

 

[Jam Racing 1]

http://www.robinsonracing.com/catalog/savage21-25.html

you cannot go wrong getting the RR 48/16 spur and bell combo... I have it on my truck and top speed is great and in a bunch of runs there is no sign of wear on either the bell or spur

 

[addicted to rc]

ya i got an rrp spur for my maxx best 25 bucks i ever spent and thanks i will experiment with that for sure

 

[Stripersniper]

I got my rr bell and spur on order, Bell came friday. They told me to get the gen 3 spur so I did. It's more expensive that just the gear. I think it has new bearing and slipper pads.

 

[Stripersniper]

Putting bell on today and least little pressure on screw starts binding drum. Any suggestions? Also noticed exhaust spring rubbing boot on carb. Think I need to move it.

 

[Odiin]

Are these the parts?
-http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXKAZ0&P=7#otheritems-
-http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXXBK6&P=7-
Just take out the - before and after

 

[X]

Are these the parts?
-http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXKAZ0&P=7#otheritems-
-http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXXBK6&P=7-
Just take out the - before and after

Looks right to me.

 

[Jam Racing 1]

Putting bell on today and least little pressure on screw starts binding drum. Any suggestions? Also noticed exhaust spring rubbing boot on carb. Think I need to move it.

possibly move or remove a shim from the bell to stop the binding, as for that spring just move it away a bit from the carb boot....

 

[Stripersniper]

possibly move or remove a shim from the bell to stop the binding, as for that spring just move it away a bit from the carb boot....

Didn't see any shims, there's a rubber washer/spacer that goes between screw and bearing. I may remove it and add a few washers. Thanks

 

[Jam Racing 1]

A couple of clear close up pics may help if you still have trouble with it...

 

[Odiin]

Looks right to me.

Do I need to find anything extra to make these work? Slipper clutch pads or anything?

 

[X]

Do I need to find anything extra to make these work? Slipper clutch pads or anything?

New slipper clutch pad and bearings should be it

 

[Stripersniper]

A couple of clear close up pics may help if you still have trouble with it...

I got it all on. Had to file down big washer so clutch drum wouldn't bind. Ran it about 5 minutes the other day. Today I hooked batt up wrong and fried servo and probably receiver ugggggg. Another week of waiting on parts.