Steering Servo Arm

[AllanQ]

I am sure this has been covered somewhere, but I couldn't find a thread in my searches. At the end of the day when I am done running the truck, I take out the radio box for a good cleaning. This time when I looked at the steering servo arm, I noticed some beveling to the arm where the screw goes into the servo horn. I will replace the arm when I do the steering mod, but what would cause this and what can I do to prevent this from happening in the future? Thanks for your help.

 

[Larsenracing]

Do you have pictures or can you take pictures of this and post them, Please.

 

[AllanQ]

Here are the pics of my steering arm

 

[Larsenracing]

To me it looks like it was to tight. I would replace that one and leave it a touch looser. Otherwise you can get the ball ends and a threaded rod and use that instaed which would also reduce some slop.

 

[AllanQ]

Larsen, what type of ball ends should I get. I am ordering parts and would rather get the ball ends instead of the entire servo/steering crank set and thanks for the replys.