soulja
Virginia Beach Beast
- Messages
- 1,748
a few guys have been asking how i did the suspension mod.... so since my savage is apart now it would be a good time to show you all. here is the sanding disc i used
all i did was took the dremel and sanded the sterring stop at an angle to matck the front hub carrier. i went from the bootom to the top and jusst took away excess material. the top should remain UNTOUCHED! *NOTE* becareful note to go too much....if you do you will bind up the steering. also watch because you could go too far and when you turn you will have so much steering that there is a possibility of the dogbone coming out of the axle. it's simple and only about a 5 or 10 minute job. post here to let me know if it works for you all!
all i did was took the dremel and sanded the sterring stop at an angle to matck the front hub carrier. i went from the bootom to the top and jusst took away excess material. the top should remain UNTOUCHED! *NOTE* becareful note to go too much....if you do you will bind up the steering. also watch because you could go too far and when you turn you will have so much steering that there is a possibility of the dogbone coming out of the axle. it's simple and only about a 5 or 10 minute job. post here to let me know if it works for you all!
Last edited by a moderator: