slipper clutch set up

[super nub i drive traxxas]

i have been away from the hobby for a long time now. i want to get back to driving my savage as i miss it a lot. when i put it away last the slipper clutch kept slipping. i have a new slipper clutch pad and have attached a photo to check if its all set up right. i would tighten the little bolt a lot and it would run nice and then start slipping again and went through two of those little slipper clutch pads. its been a while and i can not find the small bolt that goes on the end. anyone have one they would sell me? or think hobby town or someone would have one?

 

[Mickey]

from what i can see from your pic you are missing the spring and the hex washer

 

[super nub i drive traxxas]

I have the spring. You mean hex bolt? I am missing the bolt.

 

[nitrobasher]

There is a bushing then a hex washer (p/n 87402) spring (p/n 87042) nut (p/n Z684).
Here is the link to the manual, check out page 30.
http://www.hpiracing.com/manuals/pdf/867.pdf
Chris

 

[super nub i drive traxxas]

think that i could find the washer and bushing at home depot? doubt local hobby store will have them and i don't wanna wait for shipping. gotta go back to school soon

 

[nitrobasher]

Well it wouldnt hurt to to look. i have never seen that kind of washer there but I have never acually looked for one either. Good luck.
Chris