she is done.. few videos ..few question lol

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
A

avandss

Member
Messages
25
i guess this is the right section to post it in?

Finally DONE… muhahahah! Lol
Alright here it is

Savage x ss 4.6
Wheelie bar
Throttle mod
1600 hump pack
Dx3
Ofna tank (will install it this weekend)
Integy body struts (yes yes waste or money but it looks sick….)
Integy bottom cover (and that’s all for my bling bling metal parts lol she will be no shelf queen)

Soon to come axial beadlocks and some Road Rage 40's for tires!!

Anything else you guys can recommend?

Here are a few links and questions

My throttle mod, does it look ok?
http://www.youtube.com/watch?v=tsWWU08IngE

does my Car sound ok?
http://www.youtube.com/watch?v=O3De8kyJdEU

and here she is lol ( btw do you think I should cut out the front windshield and make a few holes on the side to be able to adjust the needles?
http://www.youtube.com/watch?v=EvxDPOnCShM
 
looking good!!:10: would you happen to have the part numbers for that linkage mod?
 
Why do you have the brake arm down so low? If you plan on running it like that you need to cut the bottom of it off.

In the second video it sounds like the mesh is off. Either too loose and the teeth are slapping eachother or too tight and they are hitting eachother.

As for the holes you might be ok for now since its still cool outside. But you will want to put a hole (or two) in the windshield for airflow. You shouldnt be tuning enough to need the holes in the body to reach the carb. If you need to tune just take the body off. No need to cut more holes in that beautiful body than you have to.
 
Last edited by a moderator:
ofna servo linkage kit http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXARF2&P=7

ofna linkage slide kit
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXNXL5&P=7

and it cost about 11$ for both at my lhs!!! the tank cost 6.5 lol!!! i love this hobby



Thanks alot guys for the feedback...

brakes - thanks for pointing that out i will fix it and repost the video!

noise.. how can the mesh be off? when i push it forward the spur does not even turn... is that bad? its like the transmission making that noise. any help on this would be appreciated keep in my i am a newb to the extend that when you said the brake arm is low i was like whats that lol!!!!

thanks!
 
Are all the teeth ok on your spur gear. Are they rounded off? Its realy hard to tell in the video because its moving around so much. Put it on a box so the tires are off the ground and spin the tires. The entire driveline shound spin. Spur and everything.
 
Last edited by a moderator:
it has never seen fuel yet lol!! haha ok i will do that and post a video of it..

maybe it should make it spin but for now when i just push it forward the spur stays idle as in it does not turn
 
If your spur gear doesnt turn when you move the truck something is wrong. Are the drive shafts turning?
 
You must log in or register to reply here.

Latest posts

Members online

No members online now.
Total: 825 (members: 0, guests: 825)
Back
Top