haven't used my savage for about a year (I'm still kinda new to the hobby). Today I tried starting it (with new fuel, fuly charged igniter and roto start, even primed it too) and it wont start at all. Can someone tell me if I'm doing something wrong or how do get this baby started again. Thanks.
-
Ask questions. Share your HPI Savage knowledge. Register TODAY!
Problem Starting my X 4.6 SS
- Thread starter ronnie125
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
maximusraylius
Well-Known Member
- Messages
- 2,123
welcome to the hobby i know you arent new but kinda .welcome none the less... anyways you check the glow plug? take it out put it on the igniter see if it glows alot. if not then replace it.. also if its been sitting a year ... replace the fuel lines they might have dry rot a bit nd got pin holes in them.. other than that set the needle adjustment screws to stock setting.. not sure what engine your running but most settings are set to flush ..check and make sure ... good luck and welcome to the forum again lol
wildchild27
DR. DISASTER
- Messages
- 748
- Location
- Etna Green, IN
when my truck sits for a while i always put a little wd40 in it turn it over a couple times and then start it up. and like max had said check the lines and the glow plug,also check the fuel inlet on the carb and make sure its clear and clean. WELCOME TO HPISF!!!!!
