Hey guys i purchased a new v2 4.6 engine slash motor for my used an abused savage x. It has a losi 427 in it now but is letting go. Are the flywheels an clutch bells the same for all 4.6 ? I have a spare one that is locked up so i can use the clutch bell an flywheel from that. Also what has to be changed to make it pull start ? Thanks
-
Ask questions. Share your HPI Savage knowledge. Register TODAY!
New engine
- Thread starter Popsrc
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
rcnut14
I give bad advice
- Messages
- 1,297
- Location
- lancaster county, pa
yes, the clutch system is the same for all of the 4.6 engines that I know of. in fact, most big block engines have the same clutch setup.
all you have to do to make it pull start is take the rotostart backplate off and put a pull start on it.
all you have to do to make it pull start is take the rotostart backplate off and put a pull start on it.
