Light for Savage x

[Zalex820]

Hello everyone. Once again I am seeking your help. I had added 6 led lights to my truck (4head lights 2 brake lights) I am trying to figure out how to wire them to the 3rd channel on my receiver so I won't have to use a 9volt. And also get rid of the Micro switch it came with. Thanks for your help

 

[WoodiE]

For a few lights you can wire them directly using a JR plug and plug it into your receiver. If you want more control over it you could use a light controller similar to what @Killer RC sells.

 

[RAMTech-RC]

Turnigy sells a low cost switch that owrks well for tat aplication:

http://www.hobbyking.com/hobbyking/store/__8833__Turnigy_Receiver_Controlled_Switch.html

 

[Tommyrox]

I am trying to do the same thing...did you get it to work?

 

[Zalex820]

I am trying to do the same thing...did you get it to work?

Well yes and no. ramtach-rc in the post above told me about that switch and it does work but I had decided to keep it 9volt because I bash the truck hard and it's better that no wires get pulled or yanked on the truck it self. If you bash go 9 volt with strong double sided tape. If you just drive it around buy the switch for like 15 bucks.