Just a crappy servo?

[f1n3sse]

Hey guys when I power up and pull the throttle my servo doesnt reseat my carb against the idle screw. its about an 1/8" off. I can close the carb all the way if i push it in but the servo wont reset it all the way. I'm running a z270 from a dx2 I know its not the greatest servo. do you think this is causing the problem?

 

[Bankrupter]

Adjust the end point so it closes it. If your TX cant do that adjust your linkage.

 

[f1n3sse]

I have a dx2 and I'm assuming that is a setting in there somewhere? ive adjusted my linkage twice. ill look in my manual