How do you remove the clutch and flywheel?

[measy116]

Dumb question, but how do you remove the clutch and flywheel? I have a k5.9 xl engine. Thanks in advance.

 

[ohmygahitscoby]

The clutchbell is straightforward. You remove the screw and pull off the clutchbell and bearings. With the springs, you can either pry them off or use a special tool. Prying them can damage the springs, so you may want to make a tool (There is a thread in the how to I think). Then remove the pilot nut. With the flywheel, you don't want to pry it off with a screwdriver. A flywheel puller is the best tool. It is worth its price. It pulls the flywheel off evenly so there is no damage to the crankshaft. If you were to pry it on one side, you risk the damage of bending the crankshaft.

 

[ryugaiden05]

Here are a few links to some of the tools mentioned:

Flywheel removal tool
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXSFZ6&P=7

Clutch Spring Tool
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXJKN2&P=7

Flywheel Wrench
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXBDV1&P=7

These are just examples, there are plenty to chose from, so shop around. These tools really do simplify the removal and install process.

 

[f1n3sse]

don't lose the washer that goes between the inside bearing and pilot nut or you will run into issues

 

[Pope]

just use a automotive battery terminal puller to remove the flywheel they are like 5 to 10 bucks and work great.

 

[DamoSavage]

Check your manual so you know how to take it apart and put it back together