has anyone else run into this problem?

[k0m0d067]

I bought these tie rods for my alloy monster:

http://cgi.ebay.com/TITANIUM-Tie-Ro...0QQihZ002QQcategoryZ19168QQrdZ1QQcmdZViewItem

and finally got around to installing them (or attempting to install them)...they appear to be too long, even fully collapsed, and the pivot balls don't allow them to rotate to the proper angle to attach to the bulkhead...i mean, i CAN attach them, but they bind before they get there, and the pressure will either snap them, while running, or bend something, or strip the screw threads...I haven't tried the front ones yet, but I would imagine it will be the same story as the rears...

any thoughts or suggestions?

 

[polystyrene]

i have the same on my savage and they are perfect fit. check with the seller that they sent you a pair for a savage and not another truck!??

 

[k0m0d067]

nah...the packaging has the same part numbers, etc as stated in the auction listing...

 

[polystyrene]

strange. wot arms, knuckle arm and bulkheads you using?

 

[maximusraylius]

hello i cant see the linki says been removed I'm asumeing they are by lunsford being they are titanium... if they are they will fit you just have to really crank the ends down hard to make them as small as posible imo they need to be about 1/8 inch shorter .. anyways really crank the ends down till you get a smooth fit into the ball joints.. good luck happy bashn..

 

[BIGDAN89]

way to go max for bring a thread up for 2006 woo bank i think you need to give him a cookie

 

[maximusraylius]

lmAO thats to funny i didntr even notice the date lol i saw someone looking at that thread and clicked on it and saw hardly anyone replied to it so thought ide add my 2 cents worth lol as for the cookie hell yeah ill take a cookie any day lol... keepn it alive lmao... thx dan for calling me out on that one boi can i trust you or what lmao... thx again ya doob lol

 

[Bankrupter]

 

[frddyj]

is this a mistake or did you "whipnet" your post, lol

 

[J1A1H]

haha

The message you have entered is too short. Please lengthen your message to at least 10 characters.