2QIK4U
Member
- Messages
- 23
Finally got around to finishing this off.
Used std front bumper mounts
New alloy plate...cut and bent to shape, and mounted using original screws with small rubber washers for a bit of give.
One set of driving lights mounted....had to lift them slightly to shine over the bar
Main bar is stainless braid....cut to length and wrapped with electrical tape to size down from 30mm to about 15mm. This stiffens it up but still has some bend value.
Hose clamps secure hose to tabs from the alloy mounting plate.
I'm sure its gonna break but looks pretty sick and no one else has one ?
Used std front bumper mounts
New alloy plate...cut and bent to shape, and mounted using original screws with small rubber washers for a bit of give.
One set of driving lights mounted....had to lift them slightly to shine over the bar
Main bar is stainless braid....cut to length and wrapped with electrical tape to size down from 30mm to about 15mm. This stiffens it up but still has some bend value.
Hose clamps secure hose to tabs from the alloy mounting plate.
I'm sure its gonna break but looks pretty sick and no one else has one ?