Adjusting Shift point on 2-speed

[Oscardms]

Hey guys. Just got done breaking in my savage x and I started to tune, but I can't hear the truck shift into 2nd. It rev's real high so I start to ease off the gas. What is the stock setting for the screw so I can start from there. I haven't adjusted it myself btw, it's still at the setting from the factory. Thanks.

 

[Goodesta]

well just read the manual it tells ya

 

[Fx]

well just read the manual it tells ya

That wasn't very helpful.

Remove the rubber plug from your tranny case and spin the spur till you see a opening. Hold the spur and spin the brake disk till you see 2 screws. Turn the bottom screw counter clock wise 1/2 and see if that works. The screw you are loosening is on a angle.

 

[Oscardms]

I know how to adjust it, and all that, I'm just asking what the stock setting should be. For example, is it 1-1/2 turns from flush?

 

[Fx]

Hmmm not sure about that one bud. Mega made a post about the stock settings on a 3 speed but I don't think it applies to the 2 speed.

 

[Jeremy]

its like 2 1/2 I think don't quote me on that, its easy bro, just turn the set screw clockwise 1/2 turn at a time you'll get it

edit**

its not from flush, its from all the way tightened

 

[kevinmuff]

Hmmm not sure about that one bud. Mega made a post about the stock settings on a 3 speed but I don't think it applies to the 2 speed.

think you could show me the thread for that 3 speed?
I'm interested

 

[JohnH]

https://www.hpisavageforum.com/forums/showthread.php?goto=newpost&t=2259

 

[nitrorich]

2 speed shifting

think you could show me the thread for that 3 speed?
I'm interested

i have the same problem hpi says tighting the screw and 1/1/2 out