Search results

  1. G

    Engine Cleaning Gone Wrong

    A freind came to my rescue. he works at an engineering plant, he milled the broken screw out of the shaft and spot welded an allen key to the round off screw at the back. So now i have another question, if i don't use lock tight to refit the screws is this bad? just that lock tight has caused all...
  2. G

    Engine Cleaning Gone Wrong

    it is the aluminum plate that seals the rear end. the screw on the crank shaft is just in a tiny bit to far down to cut the end without damaging the shaft and is too near the top to secure another screw. i'm guessing both screws have been placed in with lock tight. does heat effect lock tight...
  3. G

    Engine Cleaning Gone Wrong

    the engine is a F4.6 i will post pictures tomorrow as camara is at work.
  4. G

    Engine Cleaning Gone Wrong

    I stripped my third gear at the weekend. so whilst i was removing this i thought it would be good to take the engine apart and do some maintance only to my horror. i now have a usless engine. the screw on the end of the crank shaft snapped leaving about 4mm of the screw still in there and i...
  5. G

    Receiver disfunction

    I replaced the servo with just a cheap Acoms one from my battery RC car. The full throttle problems are solved. But the breaking is almost non existant now though. One thing i did notice was when i had an incoming call from my mobile. The car which was standing still suddenly went full throttle...
  6. G

    Receiver disfunction

    I found why the full throttle was jamming the servo was dieing. so not only do i need to get a radio set i also need a new servo :(
  7. G

    Aluminum Bumpers

    the arms that hold the bumper in place. theres two on each bumper. all four have snapped leaving half of a screw in the end. i managed to get the snapped screws out. but is there sumthing more robust i can get? i have had a look around the net but i had no luck.
  8. G

    Aluminum Bumpers

    I am new to using my savage off road. i bought it with Aluminum bumpers front and rear. but i also have the plastic ones. sounds dum, but from your experiences am i better to put the plastic ones back on. only advantage i could see with the metal ones is there higher so protect the case. but i...
  9. G

    Receiver disfunction

    a few weeks back i started getting very short (2 second ) dead spots maybe one every 5 minutes. usaly under full throttle. the car would not steer and would just go flat out. since then it has got alot worse it now go's into radio black out when its about a foot away from me. full throttle into...
  10. G

    .28 Engine stalls when revved

    I was down at the local BMX track doing some bashing with my savage 46. when it landed upside down and stalled. the air filter had come off and so had the feul line to the exhaust. so I reattached both. and went to restart. started fine but as soon as i go to pull off it stalls. i can get it...
Back
Top