when i first got it it wouldnt shift than i started to adjust it from the hole on the right and now it shifts but only once i also tried driving it lightly to see it i can hear 1-2 still nothing
I'm finally going to open my 3 speed because i am not get the 3 speed. I'm not sure but i think I'm going straight from 1st to 3rd so i want to know how much to adjust my 2nd and what way i should turn it I'm hoping to do it in my 1st try lol
i have been running a metal one since i bought my savage used and it works for me never have to replace my spur gear and my transmission still works lol but I'm not a pro I'm still very noobish
yes it goes forward and wheelies and the carb slide is completely shut when i use the brakes. and when i adjust the idle at the idle screw it seems like its not making a difference so i can only adjust by the remote
i have it set the wheels are spinning when its off the ground and it is almost rolling away on flat ground but still the throttle is closing tight when i press the brakes
i change to the servo saver from the X and got a hump pack and it turns good lol when i first took it out i flipped it because it turned so sharp but if i get any problems i will check that thanks for the advice
I'm like on 1.5 gallons about but i will check out the piston and sleeve tonight... when i check it do i got to take it right out? or just look at the top? lol i have never opened a motor before so what should i look for.
i recently bought a 3 speed and i already lost my rubber plug where you adjust the shift time can i buy a new one? if they sell it can someone give me a part number i didnt see anything in the manual
hi i was playing with my savage today and it back fired loud and shut off so i checked if it would start up and it did but I'm not sure if anything needs to be fixed before i play with it again