Recent content by mike16150

  1. M

    Temp Problem

    I ended up following the advice and broke the engine down - I replaced the front bearing since it was leaking and the problem went away. Thanks
  2. M

    Temp Problem

    Been away from Nitro for awhile due to work - just getting back into it and have a little problem. I have a Savage X with extended chassis with an LRP Spec 3 .28, Ofna JP4, running 17/47 with a 3 speed and I can't get my temps below 300. I'm running Byrons Gen 2 30% with O'Donnell Purple Glow...
  3. M

    LRP Tuning Help

    I changed all the lines and O-Rings and even replaced the tank. I really don't think it's running to lean because I have a nice coating on the glow plug after a run through a full tank and the glow plug isn't discolored at all.
  4. M

    LRP Tuning Help

    I know the Picco's can withstand some higher temps but I wasn't sure about the LRP - so if I'm running fine at 260-270 I should just keep running at that? I just wasn't sure why LRP stated the safe range up to 230. The pipe is an OFNA Jammin JP2 Thanks
  5. M

    LRP Tuning Help

    I got an LRP Spec 3 .28 and need some help tuning. I'm running SideWinder 30% and MC-9 Glow Plugs. According to the LRP Instructions I should be running around 230 degrees for a great tune however at 230 degrees the engine is not tuned. When I hit around 260-270 I have a perfectly tuned engine...
  6. M

    Moving a Tuned Pipe Pressure fitting

    I ended up cutting the pressure fitting off and having the hole tig welded shut then creating a new hole. Thanks for the help.
  7. M

    Moving a Tuned Pipe Pressure fitting

    I've searched the forums for this and want to be sure so I don't break anything. I just bought two tuned pipes JP-2 and JP-3 and I need to move the pressure fittings to the top of the pipe so they don't hit the TVP's. What is the best way to do this? Do they just unscrew and I drill and tap a...
  8. M

    OFNA PICCO .26 Factory Carb Settings?

    Okay - will do Thanks
  9. M

    OFNA PICCO .26 Factory Carb Settings?

    Can anyone tell me the factory base carb settings on an old Ofna PICCO .26? I'm getting mixed answers from the lhs and know one seems to have a manual. This is the original PICCO .26 that came out years ago. I spoke with nitrohouse and they said 4 turns out on the hsn and 10.5 turns out on the...
See more
Back
Top