Recent content by koolkat01

  1. koolkat01

    picco .28

    yes i got it broken in at the lhs and no I'm not running the 47/17 gearing, but going back to it beacause its really for top end slow for low end, I'm going to run the 47/17 gearing and the roto start works better than the pull start I'm having trouble with the pull start . the mill locks up
  2. koolkat01

    picco .28

    well guys i got my picco .28 and took it to lhs to have it broken in, and i was disappointed with the picco and the gearing, first after i got it home i started the truck up and i locked up on me so i got a hair dryer heated it up and was able so start it up again, then ran it for a few it felt...
  3. koolkat01

    picco .28

    later on I'm gonna get another picco from robbin and pipe but for now this all i can afford
  4. koolkat01

    picco .28

    i was gonna go with robbins work but decided to get a second mill while i have cash for two mills. u no kill two birds with one stone
  5. koolkat01

    picco .28

    wow so what do you recommend on the gearing i tested it on my axial .28 and it pulls I'm not looking for wheelies just straight speed but it bottoms out at top speed with that mill
  6. koolkat01

    picco .28

    Picco & Lrp Ok i'll keep both mills just waiting on a delivery from tower hobbies with all my stuff. now the picco has to be modded to get full power, i watched some video's and saw robbins work i no i cant get that with the gearing I'm gonna use but will stock be affective with that gearing its...
  7. koolkat01

    picco .28

    Hi guys i haven't been on here in awhile but i have read all the threads about the Picco .28 and the Lrp .28. My question is how long is the life of the mill becuase i just bought the lrp .28 and not only have i have heard some good things about the mill but more bad things at my lhs the guy...
  8. koolkat01

    axial.28

    thanks guys i did what u all said and it was the engine plate screws gear box screws and some of the screws that holds the engine plate an mill now it's runnig great thanks for the help
  9. koolkat01

    axial.28

    i just installed the mill and stripped the spur gear on the tranny i mean three of them i meshed it right put the paper threw the gears and it was ok followed hpi instruction on adjusting the gear an installing it i thought i was doing something wrong . because i have changed the gear before ...
  10. koolkat01

    looking for a mill

    hi guys i was looking for an engine for my savage x i did not know if i should buy a new piston and con rod and sleeve or a new engine money is kind of low right now i was reading a few posts and wanted to know what was sts,lrp and mach engines stands for and where to get pricing. the reason...
  11. koolkat01

    after breakin my savvy x

    i'm going to try that
  12. koolkat01

    after breakin my savvy x

    o'donnel 20%fuel and a R5 glow plug the mill is the stock F 4.1 SAVAGE X RTR
  13. koolkat01

    after breakin my savvy x

    ok thanks so back to my savvy what do you think could be the problem
  14. koolkat01

    after breakin my savvy x

    thanks savageshaun
  15. koolkat01

    after breakin my savvy x

    i had one question do you guys know anything about wonderhobby is it safe to buy from them
See more
Back
Top