Recent content by jberd

  1. J

    Rear hubs

    Got the rear hubs installed. Look great hope they hold up well.
  2. J

    Steering issues

    Update! Replaced the stripped gears in the servo. Took the aluminum servo savor apart cleaned well, lubed, sanded, and put back together. Smooth as silk. Tested on savy by holding the servo and moving the wheels. Works great. Took out for some bash time and whala went through 4 tanks...
  3. J

    Stuck in first gear.

    It sound like the truck is stuck in 1st gear. I do not hear it shift like I used to. I have played around with the shift screw anywhere from stock to 6.5 turns out and I still do not hear it shift. Maybe it is stuck in 2nd cant tell. Any Ideas. Would a worn clutch cause this?
  4. J

    Steering issues

    Thanks got it on order
  5. J

    Steering issues

    Confirmed first run and 5645 has stripped gears. :( Where is the best place to order new ones? They are all metal but one plastic one coming off the main motor. Anyway not the one that stripped. Two gears are shot.
  6. J

    Steering issues

    Also is this servo saver ok for this servo or is it too strong?
  7. J

    Steering issues

    Would you mind walking me through this?
  8. J

    Steering issues

    Not quite sure what you are saying.
  9. J

    Steering issues

    These servo's are plug and play correct. I do not have to do anything else?
  10. J

    Steering issues

    Nothing more frustating than going twice now with my buddy who has a slash and watch him go battery after battery while I am becoming more frustrated by the minute. I keep telling myself it will pay off in the end. It is not even the nitro parts that are the problem to be honest that is the...
  11. J

    Steering issues

    I think I stipped out the gears but not sure I have not take it out yet. It just sounds like it. I will loosen my spring on the servo saver and slowly tight as needed. I will also add the blue horn as seen in your picture along with the loctight. rrrrrrrrrrrrrrrr!
  12. J

    new big bores

    Well so far so good with the stock shocks. Two tanks in today with no issues. Landed some good 6 fters and some tumbles.
  13. J

    Steering issues

    I did not know they made a non metal gear version. I will take it apart and look. How tight should the servo saver be? Just so the spring starts to compress.
  14. J

    Integy MSR8 Super Heavy Duty Savage Shocks

    Update on MSR8 shocks. I could not let this rest. There has to be a reason why the shocks don't work. So far here is what I have found. The o-rings that are installed have too small of an inner diameter and are to soft and stick to the shaft. I pulled the shaft out and with the o-ring...
  15. J

    Steering issues

    Ok today was a day of many troubles. It started with the stock steering servo stripping gears. So I go to the LHS and pick up a HITEC 5645. Put it in with the ofna horn and 2 minutes in the screw backs out of the the servo and strips the horn. Put new horn on and 5 minutes later does the...
See more
Back
Top