Recent content by FluxPower

  1. F

    Tcs 1/5 flux conversion......you can"t tell what it is!!!!

    HAHAHAHAH. OMG that makes me roll on the floor. :lmao:
  2. F

    turnigy chargers

    I am, been through 20+ charges and still running good. Cheap chargers that won't dissapoint you.
  3. F

    More Shredded Gears! Not funny any more! Serious Help please

    I'm using Robinson Racing 18t pinion harden gear right now. no strip and running good. Have you ever tried the Robinson Racing ? if not give it a go. Are you running 6s setup ?
  4. F

    Lipos? what are some good ones?

    Definitely, you can get 40mph+ on stock gearing and standing backflips. Trust me 4s will blow your hat off, I recommend you go 4s first and then once you get use to it, then upgrade to 5s or 6s. 5s is the sweet spot though Good for Control/bashing/racing/high speed runs etc...
  5. F

    Lipos? what are some good ones?

    **OFF TOPIC** wow freddy. >>>> Points: 999,999,999,999,999,043,698,688.00 Bank: 9,828,229,223,510,119,777,566,720.00 Total Points: 10,828,229,223,510,119,223,918,592.00 Grats. Did you robbed the HPISF bank. LOL:bling:
  6. F

    Lipos? what are some good ones?

    Flux needs continuous of 125amps draw, thats why HPI website recommend 25C minimum. 5000mah x 35c = 175amps Continuous, 6400mah x 20c = 128 amps, It's your call buddy. :loveford:
  7. F

    what the flux is going on

    Good question. its either that or the HPI crews fell asleep at the factory.
  8. F

    what the flux is going on

    Angel I would strongly recommend you to get another set of pinion gear to sit aside, because yours is gonna strip very soon, and yeah red loctite and screw it in w/ ALL YOUR MIGHT. When I first got mine flux that damn pinion comes off every 5 min, and after 10 runs it becomes the pic below...
  9. F

    Lipos? what are some good ones?

    shark, if you are using the flux battery box, the dimension on these batts are fine 143x51x28mm, only problem is the 51mm or 50mm won't allow your battery compartment to fully close. No biggie for me because I took off the plastic taps on the lid and just strap them down. Overall those zippys...
  10. F

    3 Engine Tmaxx & still a TERD!

    he can put 5 Engine but in the end it's still a Traxsucks.
  11. F

    Noob with a hpi savage flux

    Welcome Mutton, just a heads up, your rear hub carrier will snap often at the tie rod joint, I snap mine 3 times within 2 weeks period. Get this instead Integy Silver Rear Hub Carrier.
  12. F

    How to charge Lipos in Parallel Mode.

    Good to hear Mike, less charging time, and more bash time. I see your charger max output amps is 6amps. If you get lazy changing the mah setting from 12000mah (2x6000mah LiPo) / 16000mah (2x8000mah LiPo) you can just leave it at 6000mah limit setting and charge 2 complete charge cycle for the...
  13. F

    How to charge Lipos in Parallel Mode.

    Thanks NLMD for the following vids. http://www.youtube.com/watch?v=b5p-x...layer_embedded This vid clearly shows that you can charge lipos packs even though they are in different state of voltage. (hope this answers your question Frddyj) See how he charge all 3 packs at 6.6amps@1c because he...
  14. F

    How to charge Lipos in Parallel Mode.

    Parallel is safer, I have a 5amp max charger, therefore if I want to charge a 8000mah LiPo, I can only do 5 amps since I can't do 8amps it will take me longer to charge. Well, first I would make sure both of my lipos voltage are only off by 0.1 volt or 0.2, so the charger would "see" you are...
  15. F

    How to charge Lipos in Parallel Mode.

    Pics here... To charge 2x 3S lipos What you need
See more
Back
Top