Recent content by b@3

  1. B

    savage x 4.6 rtr shocks

    I'm assuming you are talking about running 8 big bore shocks. I pretty sure that you can I've seen it done. It will be pretty stiff so you'll want to play with spring and oil combinations.
  2. B

    Mugen clutch nut?

    Oh yeah this isn't my first rodeo. I've set gear mesh hundreds of times, thanks for the heads up though.
  3. B

    Mugen clutch nut?

    Here's my new clutch set-up. Items used: dynamite max life shoes, mugen 1.0 springs(with mugen nut), acer bearings and hpi vented 15t clutch bell. I also used ofna clutch bell shim kit, which came with this little black cone washer thing to use with a hex screw. I very happy with the way...
  4. B

    Mugen clutch nut?

    Here's the mugen nut installed, much better. The spring is at a better angle and snapped right into position. Hopefully this thread can others in the future.
  5. B

    Slipper Assembly?

    I have the original savage x with the f4.1, its has the dual slipper. I just got a new stock spur gear, because my robinson racing finally wore out. My question is how nessacary is the little hex washer? With the washer the lock nut doesn't thread in very far and the spring is crooked and the...
  6. B

    Mugen clutch nut?

    I ordered a mugen nut, you just made too much sense.
  7. B

    49T Spur Gear

    I know that this is old thread, but I have the original savage x with F4.1 and it has the dual slipper clutch. I've just realized because I've been looking for new gears that HPI changed the slipper assembly. Why did they change the slipper? Is the newer single slipper better than the dual slipper?
  8. B

    Mugen clutch nut?

    Alright thanks, as I tried to get the shoe off to take the pic it did seam to be on there pretty good. Anyone else just to confirm?
  9. B

    Mugen clutch nut?

    I just got max life shoes and mugen 1.0 springs. I have the stock hpi flywheel and clutch nut. Everything is mounted, the springs seam to be at a slightly extreme angle to be on the nut. I'm a little worried that they will slip of the nut. I've read that you do need the mugen nut and that you...
  10. B

    dx3s

    Thanks I'll give it a try. Question: Would reading the output on the tranny give accurate speed ratings because of the gear changes assuming I calculated the rollout correctly?
  11. B

    dx3s

    I find that my temp readings are greatly different from telemetry to temp gun. Telemetry is 50-60F hotter. I haven't hooked up the rpm sensor. It is nice knowing the receiver voltage well using my hump pack. Be aware that the telemtry has a limited range in which it will send signal back. Also...
  12. B

    HSN turns on its own?

    Thanks guys, its kind of an intermitant problem sometimes its just fine and acts like it should and other times its not.
  13. B

    HSN turns on its own?

    What causes this? The HSN is very easy to turn and seams to wander on its own. Is it due to an o-ring problem?
  14. B

    Front diff shot can i use it 2wd?

    I tried it once just to try it(took out the front driveshaft). It was kind of cool but totally out of control. Way too much power for just two wheels. Give it a shot it is fun.
  15. B

    Car tries to move when roto starting

    Same thing happened to me the other day. Pulled the engine and took the clutch apart, grenaded bearing!
See more
Back
Top