ShiftPoint
Well-Known Member
- Messages
- 840
- Location
- Ft. Laduredale, FL
Hi,
I am posting this because I didn't see it in the Savage SS manual, so I guess it is new in the Savage X SS manual, and because I was worried about getting this correct for the simple reason it is, or was for me anyway) impossiable to see the mesh spacing, and because from what Ive read here, improper mesh spacing causes a lot of problems.
So for those of you who haven't seen this for whatever reason, heres a trick they show in the SS X version manual.
I will post a picture cut from the manual, but basically they leave a strip of paper along the bottom of the page to cut out and put between the gears, then you just tighten the motor down and roll the paper out.
Hope this helps,
John
I am posting this because I didn't see it in the Savage SS manual, so I guess it is new in the Savage X SS manual, and because I was worried about getting this correct for the simple reason it is, or was for me anyway) impossiable to see the mesh spacing, and because from what Ive read here, improper mesh spacing causes a lot of problems.
So for those of you who haven't seen this for whatever reason, heres a trick they show in the SS X version manual.
I will post a picture cut from the manual, but basically they leave a strip of paper along the bottom of the page to cut out and put between the gears, then you just tighten the motor down and roll the paper out.
Hope this helps,
John